The following list is a small sample of parts currently in stock at the Register’s spares store, more parts will be listed in due course. Please either email the Spares Coordinator or phone Andy on 01592 751738 (giving name and membership number), to enquire about any spares required.
The Wolseley Register Spares are sold in good faith, however, please note that all parts are sold as seen, untested and with no warranty.
The items are displayed in approximate ascending model age/model size order. Please click on image to see full size picture.
Gearstick & mounting:
Used. For Nine, Wasp, Hornet and possibly the New 14 -please check bolt hole postioning to confirm exact model.
Wasp, Hornet, Series III Ten Clutch Cover:
NOS & Used available.
Wasp, Hornet, Series III Ten Clutch Plate:
NOS & Used available.
Series II SuperSix 21 Propshaft:
Used. Looks OK.
Clutch Release bearing:
NOS and Used. To fit most 'inline' Wolseley models from 1936 to 1971.
All in good condition.
Clutch release bearing springs:
Used - good condition. To fit most 'inline' Wolseley models from 1936 to 1971. 2 required per car.
Series III Ten Spigot clutch bearing:
Used. 13/16" long, 13/16" outside diameter, 5/8" internal diameter. Looks OK.
Series III Ten Clutch Pedal adjusting link:
NOS & Used, ingood condition.
Includes spring & adjusting nut.
Series III Ten Propshaft:
Used. Looks OK.
Series III Ten Bell Housing:
Used. Good condition.
Series III Ten Gearbox:
Used. Less bell housing. Unknown condition.
Series III Ten Gearstick:
Used. Looks OK.
Series III 12/48 Clutch Pressure Plate:
Used.
Surface rust only.
Series III 12/48 gearboxes:
Used.
First box complete with gear stick & knob, clutch pedal mechanism, all gears selectable, appears to be in good condition.
Second box missing all of the above, unknown condition.
Series III Gearbox:
Used. All gears selectable. The actual gearbox is common to the 12/48, 14/60, 16/65, 18/85, but the bell housings and the speedo driver gears differ between the models.
Also: Dismantled Gearbox. Main internal components seem to all be present and in good condition. The box lid and gearstick are missing. Some layshaft bearings are included, but not a whole set.
Series III Clutch Pressure & Drive Plates:
Used. Unknown condition. 9" diameter, to fit 16/65, 18/85.
Series III Prop shafts:
Used.
4/44, 6/80 Gearbox Cross Shaft felt seals
NEW! Ext. dia. 24mm, int.dia. 14mm. Thickness 5mm.
6/80 Gearbox:
Used. Unknown condition.
4/44 Gearbox:
Used. Unknown condition. Several available.
4/44 gearbox cross member, with tie rod:
Used. Looks OK.
4/44 Gearchange linkages:
Used. Mixed selection
4/44 Propshaft:
Used. One UJ seized
15/50 gearbox cross member, with tie rod:
Used. Looks OK.
6/90 Series II & III Bell crank for R/H gear change:
NOS. Relay, selector lever - Part No. ACC 8297
6/90 - part of Centre Rear Gearbox Mounting:
NOS. Possibly part no. ACC5396
1500 Clutch Slave Cylinder:
Used. Several available. All require refurbishment.
1500 Propshaft:
Used
1500 Prop Shaft sliding joint:
Used.
1500 Gearknob:
Used.
1500 Gearbox:
Used. Unknown condition. Several available, one
complete with thrust bearing and cross member.
1500 Clutch:
Used. Drive plate worn. Later
23 spline clutch.
1500 Clutch Anti Rattle spring:
Used - good condition. 1 required per car.
1500 Clutch Master Cylinder:
Used. Requires refurbishment.
1500, 15/60, 16/60, 6/99 and 6/110 gearbox mountings:
NOS.
1500 6-99 6/110 Clutch Master Cylinder kit:
NOS. Lockheed.
Part no. KL71534. To fit:
1500 Mk1,2,3
6/99
6/110 Mk1,2
16/60 Gearbox:
Used. 23 splined input shaft. Unknown condition.
6/99 10" Clutch Drive Plate:
Used.
6/99 10" Clutch Pressure Plate:
Used. Light surface rust.
6/110 Mk1 Clutch pressure plate:
NOS. Part No. 75698/11.
Diameter 9.5". Has surface rust on face, but this should clean off.
6/99 6/110 Manual Gearbox:
Used. Unknown condition.
6/99 6/110 Auto Gearbox:
Used. Unknown condition.
Mini Hornet Gearknob:
Used.
1100 3rd Speed Gear:
NOS. Part number 22A 981.
Dated 01/11/1967.
1100/1300 Pivot Shaft Bearing:
NOS. Part number
B.T. 2/150, No. 24A.
1100 SPD. Fork:
NOS. Part number
B.T. 2/150, No. 24A.
18/85 Landcrab CV Joints:
Used
Six Clutch Plate:
NOS. No box, but excellent condition.
Six & Wedge Clutch Cover Assembly:
NOS. Boxed.Motaquip VCC171. To fit Six (72-75) & 22 Series (75)
Assorted Prop Shafts:
Used. All Wolseley.
Includes 6/99 6/110 auto and manual props.
Assorted Gearboxes:
Used. All Wolseley.